Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

CYCLONE CS

Use number: 007213-62/00-001

Crops
winter soft wheat, winter barley, winter oats, durum wheat
Pests
aphids as virus vectors
Area of use
Outdoors
Field of activity
Insecticide
Application technique
spraying
Growth stage
12 – 32
Applications per crop
Applications per growing season
1
authorised until
2027-06-30

Application rates

ConditionProduct rateWater rate
75 CH 200 – 300 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
durum wheat 35 days
winter oats 35 days
winter soft wheat 35 days
winter barley 35 days

Timing of application

Restrictions

Code Text Crop Buffer zone
NT108 A buffer zone of at least 5 m must be kept from adjacent areas (except agriculturally or horticulturally used areas, roads, paths and public places). In addition, in an adjoining strip of at least 20 m, the product must be applied using loss reducing equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 (Federal Gazette No 205, p. 9780) as amended, and be registered in at least drift reducing class 75 %. Neither loss reducing equipment nor a buffer zone of at least 5 m are required if the product is applied with portable plant protection equipment or if adjacent areas (field boundaries, hedges, groups of woody plants) are less than 3 m wide. A buffer zone of at least 5 m is also unnecessary if the product is applied in an area which has been declared by the Biologische Bundesanstalt in the "Index of regional proportions of ecotones" of 7 February 2002 (Federal Gazette no. 70 a of 13 April 2002), as amended, as agrarian landscape with a sufficient proportion of natural and semi-natural structures, or if evidence can be shown that adjacent areas (e.g. field boundaries, hedges, groups of woody plants) were planted on agriculturally or horticulturally used areas.
NW607-1 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 EUR.