Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

Enervin SC

Use number: 008966-00/00-001

Crops
grape vine
Pests
downy mildew of grapevine (Plasmopara viticola)
Area of use
Outdoors
Field of activity
Fungicide
Application technique
spraying or fine spraying (low volume spraying)
Growth stage
53 – 83
Applications per crop
Applications per growing season
2
authorised until
2026-12-31

Application rates

ConditionProduct rateWater rate
BAW 0.6 LH – – 400 LH
ES61 1.2 LH – – 800 LH
ES71 1.8 LH – – 1,200 LH
ES75 2.4 LH – – 1,600 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
grape vine 21 days EWTK

Timing of application

Purpose of use

Remarks

Restrictions

Code Text Crop Buffer zone
NG338-2 A maximum of 2 treatments with products containing the active substance ametoctradin within one calendar year on the same area.
NW605-1 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*".
NW606 The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. 10 m
NN234 The product is classified as slightly harmful for populations of the species Typhlodromus pyri (predatory mite).
WG734 Use of the product for spontaneous fermentation can lead to a delay in fermentation.
WW750 The maximum number of applications is limited due to active substance-specific reasons. Sufficient control is therefore not expected in all cases. If necessary, use products containing other active substances afterwards or alternately.
WW764 In order to prevent resistance, alternate with other products from different active substance groups.
WW762 Due to resistance management, do not apply the product (including other products with the same active substance, with an active substance from the same active substance group or with a cross-resistant active substance) more often than is stated in the instructions for use. If in doubt, consult extension services.