| NW701 |
Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 10 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods. |
– |
– |
| WW7091 |
Repeated applications of the product, or products of the same active substance group, or those with cross-resistance, may result or have resulted in a reduction of efficacy. To prevent resistance, the product should if possible be applied alternately with products from other active substance groups with no cross-resistance. If in doubt, consult extension services. |
– |
– |
| WW762 |
Due to resistance management, do not apply the product (including other products with the same active substance, with an active substance from the same active substance group or with a cross-resistant active substance) more often than is stated in the instructions for use. If in doubt, consult extension services. |
– |
– |
| NG365 |
Products containing the active substance cyantraniliprole must not be used in the following
calendar year on the same area. |
– |
– |
| NT108 |
A buffer zone of at least 5 m must be kept from adjacent areas (except agriculturally or horticulturally used areas, roads, paths and public places). In addition, in an adjoining strip of at least 20 m, the product must be applied using loss reducing equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 (Federal Gazette No 205, p. 9780) as amended, and be registered in at least drift reducing class 75 %. Neither loss reducing equipment nor a buffer zone of at least 5 m are required if the product is applied with portable plant protection equipment or if adjacent areas (field boundaries, hedges, groups of woody plants) are less than 3 m wide. A buffer zone of at least 5 m is also unnecessary if the product is applied in an area which has been declared by the Biologische Bundesanstalt in the "Index of regional proportions of ecotones" of 7 February 2002 (Federal Gazette no. 70 a of 13 April 2002), as amended, as agrarian landscape with a sufficient proportion of natural and semi-natural structures, or if evidence can be shown that adjacent areas (e.g. field boundaries, hedges, groups of woody plants) were planted on agriculturally or horticulturally used areas. |
– |
– |
| NW605-1 |
When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". |
– |
– |
| NW606 |
The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. |
– |
15 m
|
