| NW701 |
Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 10 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods. |
– |
– |
| NW608-1 |
When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water-bearing surface waters - the product must be applied observing the minimum buffer zone stated below. Irrespective of this, in addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times. Violations may be punished by fines of up to 50 000 EUR. |
– |
5 m
|
| NT101-1 |
In a strip at least 20 m wide which is adjacent to other areas, the product must be applied using loss reducing equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended, and be registered in at least drift reducing class 50 % (except agriculturally or horticulturally used areas, roads, paths and public places). Loss reducing equipment is not required if the product is applied with portable plant protection equipment or if adjacent areas (field boundaries, hedges, groups of woody plants) are less than 3 m wide or the product is applied in an area which has been declared by the Biologische Bundesanstalt in the "Index of regional proportions of ecotones" of 7 February 2002 (Federal Ga-zette no. 70 a of 13 April 2002), as amended, as agrarian landscape with a sufficient proportion of natural and semi-natural structures. |
– |
– |
| WW750 |
The maximum number of applications is limited due to active substance-specific reasons. Sufficient control is therefore not expected in all cases. If necessary, use products containing other active substances afterwards or alternately. |
– |
– |
| WW7091 |
Repeated applications of the product, or products of the same active substance group, or those with cross-resistance, may result or have resulted in a reduction of efficacy. To prevent resistance, the product should if possible be applied alternately with products from other active substance groups with no cross-resistance. If in doubt, consult extension services. |
– |
– |
