« Indications · to the product
Fulial
Use number: 00B116-00/00-026
- Crops
- ornamentals
- Pests
- powdery mildew (Podosphaera xanthii), white rust of chrysanthemum (Puccinia horiana), powdery mildew of rose (Sphaerotheca pannosa), white rust of crucifers (Albugo candida), grey mould (Botrytis cinerea), Alternaria species (Alternaria spp.), downy mildew (Peronosporaceae), Phoma species, late blight (Phytophthora infestans), septoria-species (Septoria spp.), Pythium species (Pythium spp.)
- Area of use
- Outdoors
- Field of activity
- Fungicide
- Application technique
- spraying
- Growth stage
- 13
- Applications per crop
- –
- Applications per growing season
- 2
- authorised until
- 2028-05-31
Application rates
| Condition | Product rate | Water rate |
|---|---|---|
| 1 LH | 1,000 – 1,500 LH | |
| AMK | 3 LH | – |
Pre-harvest intervals
| Crop | Pre-harvest interval | Remarks | excluded |
|---|---|---|---|
| ornamentals | – | The setting of a PHI is without any relevance. | – |
Timing of application
- in case of danger of infection and/or after warning service appeal
Restrictions
| Code | Text | Crop | Buffer zone |
|---|---|---|---|
| NW706 | Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters- there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 20 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods. | – | – |
| NW606 | The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. | – | 5 m |
| NW605-2 | When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". | – | – |
| NG405 | Not to be used on drained surfaces. | – | – |
| WW750 | The maximum number of applications is limited due to active substance-specific reasons. Sufficient control is therefore not expected in all cases. If necessary, use products containing other active substances afterwards or alternately. | – | – |
| WW764 | In order to prevent resistance, alternate with other products from different active substance groups. | – | – |