Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

MIRROR

Use number: 024256-61/00-002

Crops
grape vine
Pests
black rot of grapevine
Area of use
Outdoors
Field of activity
Fungicide
Application technique
spraying or fine spraying (low volume spraying)
Note on the crop
NPAWW
Applications per crop
Applications per growing season
8
authorised until
2028-02-15

Application rates

ConditionProduct rateWater rate
BAW 1 LH – – 400 LH
ES61 2 LH – – 800 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
grape vine 35 days EWK

Timing of application

Restrictions

Code Text Crop Buffer zone
NW605-2 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*".
WG734 Use of the product for spontaneous fermentation can lead to a delay in fermentation.
SF1891 Re-entering the treated areas/crops is only possible on the day of application wearing personal protective equipment which is specified for applying the particular product. Successive work on/in treated areas/crops may fundamentally not be carried out until 24 hours after applying the product. Within the first 48 hours, protective suits against pesticides and standard protective gloves (plant protection) are to be worn.
NN134 The product is classified as harmless for populations of the species Typhlodromus pyri (predatory mite).
NW706 Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters- there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 20 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods.
NW606 The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. 20 m