| SF245-02 |
It must be ensured that treated areas/crops may not be entered until the film of the plant protection product has dried. |
– |
– |
| SF276-ZB |
After application in ornamentals and nursery, it must be ensured that long-sleeved working clothes, sturdy footwear and protective gloves are worn during successive work/inspections with direct contact with the treated crops/areas. |
– |
– |
| NW800 |
Application not allowed on drained areas between 1 November and 15 March. |
– |
– |
| NW705 |
Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 5 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods. |
– |
– |
| NW606 |
The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. |
– |
10 m
|
| NW605-1 |
When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". |
– |
– |
