« Indications · to the product
BADGE WG
Use number: 028956-00/00-001
- Crops
- grape vine
- Pests
- downy mildew of grapevine (Plasmopara viticola)
- Area of use
- Outdoors
- Field of activity
- Fungicide
- Application technique
- spraying or fine spraying (low volume spraying)
- Applications per crop
- –
- Applications per growing season
- 5
- authorised until
- 2026-12-31
Application rates
| Condition | Product rate | Water rate |
|---|---|---|
| BAW | 0.625 KH | – – 400 LH |
| ES71 | 1.875 KH | – – 1,200 LH |
| ES75 | 2.5 KH | – – 1,600 LH |
Pre-harvest intervals
| Crop | Pre-harvest interval | Remarks | excluded |
|---|---|---|---|
| grape vine | 21 days | – | – |
Timing of application
- from BBCH 13 to 57 and 71 to 83
- in case of danger of infection and/or after warning service appeal
Purpose of use
- use as wine grape
Remarks
- AA0033
Restrictions
| Code | Text | Crop | Buffer zone |
|---|---|---|---|
| NN234 | The product is classified as slightly harmful for populations of the species Typhlodromus pyri (predatory mite). | – | – |
| NW607-2 | When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 EUR. | – | – |
| NW706 | Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters- there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 20 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods. | – | – |